User's Manual
4
It’s now time to sync your MultiSensor with a Z-Wave network. The
following instructions explain how to do this using a Z-Stick or a
Minimote from Aeotec. If you’re using an alternative controller for
your Z-Wave network, please refer to its user manual for network
inclusion instructions.
If you’re using a Z-Stick:
For a battery powered installation;
1. Remove the rear part of your sensor as shown in the previous
step 1.
2. Insert CR123A batteries oriented according to the picture below.
Your MultiSensor is now powered on.
Add your MultiSensor to your Z-Wave network.
Security or Non-security feature of your MultiSensor in
Z-wave network.
Resetting your MultiSensor.
If you want your MultiSensor as a non-security device in your
Z-wave network, you just need to press the Action Button once on
MultiSensor when you use a controller/gateway to add/include your
MultiSensor.
In order to take full advantage of all functionality the MultiSensor,
you may want your MultiSensor is a security device that uses
secure/encrypted message to communicate in Z-wave network, so
a security enabled controller/gateway is needed for the Multisensor
to be used as a security device.You need to press the MultiSensor’s
Action Button 2 times within 1 second when your security controller/
gateway starts the network inclusion.
At some stage or your primary controller is missing or inoperable,
you may also wish to reset all of your MultiSensor’s settings to their
factory defaults. To do this, press and hold the Z-Wave Button for
20 seconds and then release it. Your MultiSensor will now be reset
to its original settings, and the LED will stay solid for 2 seconds and
then turn off as a conrmation.
Model number: ZW100
Power Supply: USB DC 5V or battery power(2×CR123A batteries,
Technical specications.
17