User's Manual

The Back-Mount Arm may be locked at various angles by turning
the Friction Lock clockwise and counter-clockwise to respectively
tighten or loosen the angle of the arm.
5.
Lock
Unlock
Screw hole
60°
10
Your MultiSensor has built in battery level detection. It will
automatically report its battery level to the associated controller/
gateway throughout its life until the battery is fully drained and
needs replacing. The battery status will often be displayed in the
user interface of the controller/gateway.
When used properly in an optimised Z-Wave network, your
MultiSensor can be powered by batteries for 24 months before
battery replacement is necessary.
Recommendation: For networks which do not offer a method to
display the battery level of your MultiSensor, it is recommended that
the sensor be tested occasionally to ensure that the batteries still
hold enough charge to operate. Batteries naturally lose their charge
over time.
Your MultiSensor can be removed from your Z-Wave network at
any time.You’ll need to use your Z-Wave network’s main controller
to do this and the following instructions tell you how to do this using
Aeotec by Aeon Labs’ Z-Stick and Minimote controllers. If you are
using other products as your main Z-Wave controller, please refer
to the part of their respective manuals that tells you how remove
devices from your network.
If you’re using a Z-Stick:
Changing batteries.
Removing your MultiSensor from a Z-Wave network.
Advanced functions.
11