User Manual

small Z-Wave network and have decided to expand it. Your Key Fob Remote Control has

been designed to cater.

To demote it to a secondary controller and pass all its knowledge on to a new controller:

1. Press the Learn button on the new controller. If you’re unsure of how to do this, refer to

its user manual.

2. Press the learn button on the Key Fob Remote Control. The green and red light are

blinking when Key Fob Remote Control is learning, and the green light on your Key Fob

Remote Control will stay lit for 2 seconds when successful. If learn unsuccess, the red

light on the Portable Panic Button will stay lit for 2 seconds, then repeat from start step

1 again

Resetting your Key Fob Remote Control

If you ever want to completely reset your Key Fob Remote Control’s settings, you can.

1. Using a pin or a paper clip, press and hold the Mode button 10 seconds.

2. The green and red light are blinking when Key Fob Remote Control is resetting, and

the green light on your Key Fob Remote Control will stay lit for 2 seconds when

successful. If learn unsuccess, the red light on the Portable Panic Button will stay lit for

2 seconds, then repeat from start step 1 again

Tip: Changing the battery

Batteries eventually do run out. While your Key Fob Remote Control has been designed to

last for 1 months of normal use, there will come a time when you’ll need to change its

battery.

1. Push down on the grip on the bottom and slide the battery cover away from the remote.

2. Remote the existing battery.

3. Replace it with a lithium cell CR2450 3 volt battery by placing a new one in the battery

cover with the positive touching the plastic.

4. Slide the battery cover back on to your remote control.

Technical Specifications

Operating distance: Up to 66 feet / 20 metres indoors and150 feet / 45 metres outdoors.

Battery: lithium cell CR2450 3 volt battery

Aeon Labs LLC.