Instruction Manual

• Associating Z-Wave Lights/Switches/Gateways to Z-Wave Sensors in the Network
1. Press the button labeled “Associate” – The blue LED will blink slowly to indicate that
the Minimote has entered Association-Mode.
2. Press the Z-Wave button on the product you wish the sensor to communicate to -
The blue LED will blink quickly to indicate detection of the Z-Wave device.
3. Press the Z-Wave button on the sensor - The blue LED will stay solid for 2 seconds
to indicate success, the red LED will stay solid for 2 seconds to indicate failure.
4. Repeat step #3 for all sensors you wish to be controlling the device in step #2 or
press any button on the Minimote to exit Association-Mode. (The blue LED should
be blinking quickly again as in step #3.)
• Becoming a Secondary/Inclusion Controller to Another Z-Wave Controller or Gateway in
an Existing Z-Wave Network
1. Press the button labeled “Learn” – The blue LED will blink slowly.
2. Press the button labeled “Include” on the other Z-Wave controller - The blue and
red LEDs will blink quickly to indicate detection of the other Z-Wave controller.
Consult the operation manual of other controllers for instructions on how to add
the Minimote as a secondary/inclusion controller into an existing network.
3. The blue LED will stay solid for 2 seconds to indicate success; the red LED will stay
solid for 2 seconds to indicate failure.
• Resetting the Minimote
1. Press and hold both the buttons labeled “Associate” and “Learn” for 10 seconds –
The red LED will blink from slow to fast.
2. The blue LEDs will stay solid for 2 seconds to indicate success.
• Rediscovering/Healing/Fixing the Z-Wave Mesh Network
1. Press and hold the button labeled “Include” 10 seconds – The blue and red LED will
blink quickly to indicate the rediscovery has begun.
2. The blue LEDs will stay solid for 2 seconds to indicate success.