Instruction Manual

Minimote Network Functions:
• Inclusion-Mode : Adding/Including Z-Wave Devices into the Z-Wave Network
1. Press the button labeled “Include” – The blue LED will blink slowly to indicate that
the Minimote has entered Inclusion-Mode.
2. Press the Z-Wave button on the product you wish you add into the network - The
blue and red LED will blink quickly to indicate detection of the Z-Wave device being
added.
3. The blue LED will stay solid for 2 seconds to indicate success; the red LED will stay
solid for 2 seconds to indicate failure.
4. Repeat step #2 for all products you wish to add into the Z-Wave network or press
any button on the Minimote to exit Inclusion-Mode. (The blue LED will be blinking
slowly as in step #1 while in Inclusion-Mode.)
Note: Secondary Controllers are not able to include Z-Wave products; the LED will stay
solid red for 2 seconds to signify this before exiting Inclusion-Mode.
• Removal-Mode : Deleting/Removing/Excluding Z-Wave Devices from the Z-Wave Network
1. Press the button labeled “Remove” – The red LED will blink slowly to indicate that
the Minimote has entered Removal-Mode.
2. Press the Z-Wave button on the product you wish you remove from the network -
The blue LED will stay solid for 2 seconds to indicate success; the red LED will stay
solid for 2 seconds to indicate failure.
3. Repeat step #2 for all products you wish to remove from the Z-Wave network or
press any button on the Minimote to exit Removal-Mode. (The red LED will be
blinking slowly as in step #1 while in Removal-Mode.)
Note: Secondary Controllers are not able to remove Z-Wave products; the LED will stay
solid red for 2 seconds to signify this before exiting Removal-Mode.