User Guide

Data Logger Models DL913 & DL914 Quick Start Guide 7

These tasks can be completed through either the instrument front panel or

DataView

. In addition, the Control Panel allows you to set a number of other

parameters, including conguring Permanent mode, changing communication

settings, erasing memory, and others. Detailed information for conguring the

instrument via the DataView Data Logger Control Panel is available by pressing

the Help button.

To change the following settings via the instrument front panel:

Wi-Fi Type:

1. Press

twice.

The message WIFI AP (Wi-Fi access point), WIFI ST (Wi-Fi Station), or WIFI

OFF will appear at the bottom of the display.

Wi-Fi AP (Wi-Fi access point) enables Wi-Fi Direct.

Wi-Fi ST (Wi-Fi Station) enables Wi-Fi via router.

Wi-Fi OFF turns the Wi-Fi o󰀨.

2. Press

to cycle through the options.

Selecting a setting automatically enables it.

Enabling/Disabling Wi-Fi:

When Wi-Fi is enabled, the word ON and either the

(Wi-Fi via router) or

(Wi-Fi Direct) icons are displayed in the conguration screen.

1. To change the setting, press ◄ or ► to highlight

2. Then, press

to switch between enabled and disabled.

Current Range:

1. Press either ◄ or ► until

is highlighted.

2. Use ▲ or ▼ to display the I RANGE screen.

3. Press

to toggle between 300 A and 3000 A and the number of turns the

sensor is wrapped around the conductor (1 to 3).

Aggregation Period:

1. Press either ◄ or ► until

is highlighted.

2. Use ▲ or ▼ to display the AGG PER screen.

3. Press

to cycle between 1, 2, 3, 4, 5, 6, 10, 12, 15, 20, 30, and 60

minutes.