User Guide

ManualsBrandsAEMC ManualsData LoggerAEMC DL913 Data Logger

Data Logger Models DL913 & DL914 Quick Start Guide 5

Charging the Battery

1. Press the button to turn the instrument ON.

2. If the battery indicator is less than full (for example

), connect the

instrument to external power via the provided USB cable. The battery

indicator will blink to indicate that the battery is charging.

3. When the battery is fully charged, the battery indicator will stop blinking and

appear completely lled (

Initial Setup

WARNING: Connect the instrument to the DataView

control panel to

set the date before rst use.

Some features can be congured through the instrument keypad, such as

enabling the Wi-Fi type. Other features require a connection between the

instrument and DataView

for conguration. For detailed setup instructions,

reference the user manual in the USB drive that comes with the instrument.

To connect your instrument to your computer:

1. Install the DataView

software. Make sure to select the Data Logger Control

Panel as an option (it is selected by default). Deselect any Control Panels

that you do not need.

If you plan to create DataView reports, you must also check the option

DataView

Core.

Precautions Before Use

These instruments comply with safety standard IEC 61010-2-032 for voltages

and categories of installations at an altitude below 6500 ft (2000 m) and are

rated for 600 V CAT IV installations with a degree of pollution equal to 2. Failure

to observe the following safety instructions may result in electric shock, re,

explosion, damage to the instrument, or damage to other equipment.

■

The operator and responsible authority must read and understand the

precautions needed before using the instrument

■

This instrument requires the user to have knowledge and awareness of

electrical hazards

■

Observe the conditions of use, including temperature, relative humidity,

altitude, pollution degree, and location of use.

■

Do not use the instrument if it appears damaged, incomplete, or improperly

closed

■

Before each use, check the condition of the housing and accessories. If the

insulation is deteriorated (even partially) on any item, it must be set aside

for repair or scrapping

■

All troubleshooting and calibration checks must be completed by accredited

personnel

■

Do not apply or remove the sensors from hazardous live parts or systems