Specifications

AA24/AA25 Series Single User Audio Controller
SM18 Installation and Operation Manual
April 14, 2012 Rev: 5.00 Page 2-1
ENG-FORM: 805-0100.DOTX
CONFIDENTIAL AND PROPRIETARY TO ANODYNE ELECTRONICS MANUFACTURING CORP.
Section 2.0 Installation
2.1 General
Information in this section consists of unpacking and inspection procedures, installation procedures, post-
installation checks, and installation drawings.
2.2 Unpacking and Inspection
Unpack the equipment carefully. Inspect the unit visually for damage due to shipping and report all such
claims immediately to the carrier involved. Note that each complete unit should have the following:
- AA24-001 or AA25-001 Audio Controller
- Product Information Card
- Release certification
Verify that all items are present before proceeding and report any shortage immediately to your
supplier.
2.2.1 Warranty
All Anodyne Electronics Manufacturing Corp. (AEM) products are warranted for 2 years. See the website
www.aem-corp.com/warranty for complete details.
2.3 Installation Procedures
2.3.1 Warnings Í
Í
IMPORTANT!
Do not bundle any lines from this unit with transmitter coax lines. Do not bundle any logic, audio
or DC lines from this unit with 400 Hz synchro wiring, or AC power lines. Do not position this unit
next to any device with a strong alternating magnetic field such as an inverter, motor or blower, or
significant interference to operation will result.
2.3.2 Cautions
In all installations, use shielded cable exactly as shown and ground as indicated. Significant problems
may result from not following these guidelines.
Do not ground the microphone or headphone jacks.
Do not connect the microphone and headphone shields together.
Use caution when routing microphone and ICS Tie Line wiring, as they are low level signals prone to
coupling form other sources.