Installation Manual

6
i. Install the straight coupler with hose clamps onto the
AEM tube. Note: Use soap and water to allow the cou-
pler to slide on the intake tube.
j. Install the assembled AEM intake tube and heat shield
into the vehicle. Align the heat shield into the lower air
box and latch the clips to secure it in place.
k. Align the AEM intake tube with the step coupler that
was previously installed in step 3h. Tighten the hose
clamp circled at this me.
l. Install the straight coupler with hose clamps onto the
stock upper intake tube. Tighten both hose clamps at
this me.
m. Connect the air temperature sensor connecter onto
the air temperature sensor that was removed in step 2b.