Installation Manual

5
c. Install the provided edge trim onto the heat shield as
shown. Note: Trimming the edge trim maybe necessary.
d. Install the AEM lter into the heat shield with the
provided hose clamps.
h. Install the step coupler with the provided hose clamps
onto the lower intake tube as shown. Tighten hose
clamp circled.
f. Install the AEM intake tube into the AEM air lter
while aligning the rubber mount with the bracket on the
intake tube. Tighten the hose clamps on the lter.
g. Install the provided nut and washer onto the AEM
intake tube bracket, then ghten both sides.
e. With the provided hardware, install the rubber
mount/washer/nut onto the heat shield tab.