Installation Manual

4
e. Remove the stock air intake system from the vehicle.
Note: Do not discard any of your stock equipment.
f. Remove your stock air lter from the lower air box.
g. Remove the air intake temperature sensor from the
stock intake tube. Note: This will be reused in step 3b.
h. Remove the O-ring from air temperature sensor.
Note: The O-ring will not be reused.
a. Install the provided grommet into the AEM intake
tube.
b. Install the air temperature sensor that was removed
in step 2g into the AEM intake tube.
3. Installation of AEM
®
intake system.
a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until
instructed to do so.