Instruction Manual

Page 7
Figure 6. PC Data Viewer
The grey wire from the UEGO Controller outputs the data stream in an RS232 serial
format. To connect to the pc/laptop, an RS-232 DB-9 connector is recommended. The
grey wire from the UEGO Controller goes to pin 2 of the RS-232 DB-9 connector. Pin 5
of the connector goes to ground. See Figure 7.
1 2 3 4
5
6 7 8
9
Figure 7. Wire View of RS-232 (DB-9) Male Plug
Connector Pinouts
The pinout for the UEGO sensor connector is shown below in Figure 8.
Figure 8. UEGO Connector Pinout