User Manual

AEM Performance Electronics

2205 126

Street Unit A, Hawthorne, CA. 90250

Phone: (310) 484-2322 Fax: (310) 484-0152

http://www.aemelectronics.com

Instruction Part Number: 10-2131 Rev C

 2012 AEM Performance Electronics

The model 30-2131-XXX family of pressure transducers is specifically designed for pressure measurements in automotive systems. The mechanical

connection is 1/8" Male NPT. Each sensor comes with a mating connector plug and pin kit. Sensors are not recommended for use with methanol.

Instruction Manual

P/N 30

XXX

Pressure

Sensor

Kit Contents

Part Number Sensor Connector

30-2131-15G 15 Psig Included

30-2131-30 30 Psia (2 Bar) Included

30-2131-50 50 Psia (3.5 Bar) Included

30-2131-75 75 Psia (5 Bar) Included

30-2131-100 100 Psig Included

30-2131-150 150 Psig Included

Spec

ifications:

Accuracy (Temp Included): < +/- 3% FS

Mounting Torque: 14.7 ft-lbf

Operating Temp: -20 to 105C

Burst Pressure: 2 X FS

Supply Voltage: 5V +/- 0.25V

Supply Current: 4.5 mA at 5VDC

Weight: < 60 Grams

Body Material: Brass

Wetted Material: 316L

Mechanical Connection: 1/8”NPT Male

Electrical Connection: Packard 3-Pin

Electrical Termination:

Signal Ground: Tap to Sensor/Signal Ground on EMS or AQ1

Sensor Power: Tap to Sensor Power +5V on EMS or AQ1

Signal: Connect to MAP/Input Channel on EMS or Input 1-8 on AQ1

PAGE 1
Instruction Manual P/N 30-2131-XXX Pressure Sensors The model 30-2131-XXX family of pressure transducers is specifically designed for pressure measurements in automotive systems. The mechanical connection is 1/8" Male NPT. Each sensor comes with a mating connector plug and pin kit. Sensors are not recommended for use with methanol. Part Number 30-2131-15G 30-2131-30 30-2131-50 30-2131-75 30-2131-100 30-2131-150 Kit Contents Sensor 15 Psig 30 Psia (2 Bar) 50 Psia (3.
PAGE 2
IMPORTANT! The terminals are “Pull to Seat” meaning you must feed the wire through the connector housing BEFORE you crimp on the terminals. The wire is then pulled back into the housing and the terminal locks in place. The terminal cannot be inserted or removed from the rear (wire side entry) of the housing. See Figure 1. Below Figure 1. Connector Assembly Showing Pull to Seat Terminal VOLTAGE OUTPUT Voltage 30-2131-15G 30-2131-30 30-2131-50 30-2131-75 30-2131-100 30-2131-150 Range 0-15 PSIg -14.