Owner manual

Page 8
Connect all three F/IC grounds. See Figure 12.
ECU
FIC
POWER GND
TO GROUND
PWR GND
GROUND CONNECTION
TO GROUND
POWER GND
PWR GND
TO SIG GND
SIGNAL GND
SIG GND
Do you want to use the Switched 12 volt dc source from the F/IC?
If so, connect the “Switched 12 Volt” source wire as shown below. (Note: The
driver can handle 1 amp Max.) See Figure 13.
LOW CURRENT
RELAY/SOLENOID
SWITCHED 12 VDC CONNECTION
FIC
SW12
Figure 12. Power Ground Connections
Figure 13. Switched 12Vdc Connection