Owner's manual

Page 6
Do you want to modify or clamp the MAF Sensor voltage?
If not, the two MAF Sensor wires can be eliminated. If so, connect the MAF
Sensor as shown below in Figure 9.
MAF IN +
FIC
SIGNAL (+)
SENSOR
GND
VREF
MAF OUT +
ECU
Figure 9: MAF sensor connection
Does your vehicle have both a MAP Sensor and a MAF Sensor? Or do you want to
remap another analog signal on your car?
If so, connect the “Analog A/B” wires as shown below in Figure 10. If not, remove
the unused wires for “Analog A/B”.
ANALOG A/B IN +
FIC
SIGNAL (+)
SENSOR
GND
VREF
ANALOG A/B OUT +
ECU
Figure 10: Analog A/B connection