Owner's manual

Page 25

MAF:

Select the load input and operating mode for the MAF map. Set the

maximum voltage clamp (max output voltage) for the MAF map.

Analog A(B):

Select the load input and operating mode for the Analog A(B) map.

O2:

Select the load input and operating mode for the O2 map. Set the period

for the fixed and percentage modes. Set the high and low voltages for bank 1

and bank 2. Set the Start Delay time, which is the amount of time in seconds that

the F/IC waits for the O2 outputs to be functional after the F/IC is turned on.

Select the High Level Drive option (This option allows for better AFR resolution

on certain vehicles with UEGO style oxygen sensors). Select the view as AFR

option.

F/IC Logger:

Set the on conditions and sample rate for the F/IC internal logger. Note:

The on conditions must be met and the logger trigger input must be grounded

before the internal logger will begin logging.

Switched 12V

Set the on/off conditions for the Switched 12 V

output wire.

Connecting to the F/IC:

(Note: when connecting to the F/IC for the first time, the found new hardware

window will appear. The USB drivers will load automatically.)

Connect the F/IC to the PC using the supplied USB cable. With a calibration already

open, click on the connect button to connect to the F/IC. See Figure 36.

Figure 38: Connect icon

(Note: If the opened file does not match the file in the F/IC, a window will appear, asking

if you want to copy the PC file to the F/IC or if you want to copy the F/IC file to the PC.

Follow the on-screen instructions to proceed. See Figure 39.)