Installation Manual

8
For technical inquiries
e-mail us at
[e-mail]
or
call us at
800.992.3000
4. Reassemble Vehicle
a.
Wheel:
Install the passenger side wheel using the factory torque specification (see owner’s manual).
b. Position the inlet pipes for the best fitment. Be sure that the pipes or any other components do not contact
any part of the vehicle. Tighten the rubber mount, all bolts, and hose clamps.
c. Check for proper hood clearance. Re-adjust pipes if necessary and re-tighten them.
d. Inspect the engine bay for any loose tools and check that all fasteners that were moved or removed are
properly tightened.
e. Reconnect negative battery terminals and start engine. Let the vehicle idle for 3 minutes. Perform a final
inspection before driving the vehicle.
5. CARB Sticker Placement
a. The C.A.R.B. exemption sticker, (attached), must be visible under the hood so that an emissions
inspector can see it when the vehicle is required to be tested for emissions. California requires testing
every two years, other states may vary.
6. Service and Maintenance
a. It is recommended that you service your AEM
®
Dryflow™ filter every 20,000 miles for optimum
performance. Use AEM Dryflow cleaning kit part # 21-110.
b. Use aluminum polish to clean your polished AEM
®
intake tube.
c. Use window cleaner to clean your powder coated AEM
®
intake tube.
(NOTE: DO NOT USE aluminum
polish on powder coated AEM intake tubes)
Factory air box system
AEM
®
intake system installed