Installation Manual

7
Trim
m. Trim the passenger’s side under tray as shown.
Reinstall the under trays, trimming or notching them
for tube clearance where required.
l. Trim the inner fender liner and under tray as shown
for proper fit.
o. Ensure the air filter is not touching any part of the
vehicle. Position the inlet pipe for best fitment. Be
sure that the pipe or any other component is not in
contact with any part of the vehicle. Tighten the hose
clamps at the throttle body and silicone coupling.
Tighten the nut on the mounting bracket. Check for
proper hood clearance. Re-adjust pipe if necessary.
Install Duck Bill Drain Here
n. Install the AEM
®
air filter on to the end of the inlet
tube. Push the air filter over the inlet pipe until the
stop in the air filter is reached. Then install the #56
hose clamp to secure the filter onto the inlet pipe.
Once fitment is checked, tighten the hose clamp.
Install the duck bill drain into the ½” hole in the pipe.