Installation Manual

5
d. Install the 2.75” hose on to the throttle body using
the #44 hose clamps. Check to see that the inside of
the AEM
®
inlet pipe and air filter are clean and free
from any foreign objects and/or obstructions.
e. Using the factory bolt, secure the air control
solenoid valve to the bracket on the upper cold air
pipe as shown.
½” Breather Hose
3/4” OEM Breather Hose
f. Install the upper Intake pipe by inserting the end
with the smaller nipple into the 2.75” hose on the
throttle body. Attach the ½” breather hose and the
¾” breather hose as shown. Use the factory hose
clamp on the ¾” hose and the supplied hose clamp
on the ½” hose.
g. Install the supplied rubber mount into the
passenger side radiator support frame rail as shown.
When tightening the nut, tighten until the thin outer
wall of the support starts to deflect (See next picture
g. for closer view).