Installation Manual

4
3. Installation of AEM
®
intake system.
a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until
instructed to do so.
e. CAUTION: Ensure the engine is completely
cool before removing the coolant hose, or hot
coolant will escape from the cooling system and
cause injury or damage. Be sure to capture any
lost coolant in a clean container.
Remove the metal tubing loom, which will include the
breather hose, coolant hose and air control solenoid
valve vacuum hoses. Make sure to note proper hose
routing. (Place a rag under the loom, as coolant will
leak from the lower hose).
Lower Vacuum Hose
Upper Vacuum Hose
Remove
Clamp Both Ends
b. Install the provided 5/16” hose between the throttle
body and the bleeder outlet vacated by the removal
of lower hose of the metal tube loom. Use the factory
hose clamps as shown.
NOTE: Replace any coolant recovered during
hose removal by replenishing the recovery tank.
c. Replace the factory air control solenoid valve
vacuum lines with the supplied 5/32” lines, as shown.
Use the two supplied zip ties to zip tie the hoses
away from the serpentine belt. Install the supplied
breather hose onto the valve cover nipple using the
supplied #44 hose clamps.
Supplied 5/32” Lines
Lower Vacuum Hose
Valve Cover Nipple