Installation Manual

Read and understand these instructions BEFORE attempting to install this product.

Failure to follow installation instructions and not using the provided hardware may

damage the intake tube, throttle body and engine.

1. Preparing Vehicle

a. Make sure vehicle is parked on level surface.

b. Set parking brake.

c. If engine has run in the past two hours, let it cool down.

d. Disconnect negative battery terminal.

e. Do not discard stock components after removal of the factory system.

2. Removal of stock system

a. Disconnect breather hose and any vacuum lines (if they are present) from the air inlet tube.

b. Loosen and remove the air inlet tube from the throttle body.

c. Loosen and remove the stock air box from the vehicle

NOTE: It is not necessary to remove the stock resonator from inside the fender well.

3. Installation of AEM

intake system.

a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until

instructed to do so.

b. Some applications retain the O.E. PCV breather pipe. If the O.E. PCV pipe lines up with a hole then install

the 3/8” I.D. grommet into the hole. If the O.E. PCV pipe lines up with a nipple then move to the next step.

c. Install one black connector hose on the throttle body end of the inlet pipe. That is the end closer to the

breather nipple.

d. Install two hose clamps on the connector hose and just snug them down on the hose.

e. Slide the throttle body end of the inlet pipe onto the throttle body.

f. Gently tighten the hose clamps so that the pipe can still be rotated.

NOTE: If your application does not have a support tab then skip to step 3h.

g. Some applications have a support tab that is welded onto the inlet pipe.

i. The support tab on the inlet pipe will line up with a threaded hole on the inner fender well. Install the rubber

isolator mount and attach the air inlet tube onto the rubber mount. Install the large fender washer and the

lock nut onto the isolator mount stud and snug it down.

NOTE: Failure to install the rubber mount will void all warranties of the AEM

intake system.

The

diagram below describes the proper installation of the rubber mount.