Installation Manual

4. Reassemble Vehicle

a. Position the inlet pipes for the best fitment. Be sure that the pipes or any other components do not contact any part

of the vehicle. Tighten the rubber mount (if applicable), all bolts, and hose clamps.

b. Check for proper hood clearance. Re-adjust pipes if necessary and re-tighten them.

c. Inspect the engine bay for any loose tools and check that all fasteners that were moved or removed are properly

tightened.

d. Reconnect negative battery terminals and start engine. Let the vehicle idle for 3 minutes. Perform a final inspection

before driving the vehicle.

5. CARB Sticker Placement

a. The C.A.R.B. exemption sticker, (attached), must be visible under the hood so that an emissions inspector can see

it when the vehicle is required to be tested for emissions. California requires testing every two years, other states

may vary.

l. Attach the AEM

Dryflow™ air filter to the end

of the intake pipe using the #52 hose clamp. Use

the supplied zip tie to secure the heat shield to the

support bar.

Factory air box system installed AEM

intake system installed