Installation Manual

f. Insert the intake pipe into the rubber coupler

attached to the throttle body.

g. Align the intake pipe with the heat shield and

rubber mount. After alignment is achieved, secure

the heat shield with the supplied M8 bolt, washers

and nut to the fender well of the vehicle.

h. Secure the intake pipe to the rubber mount by

using the supplied 6mm nut and washer.

i. 2005-2006 Vehicles: Carefully install the IAT

sensor into the intake pipe.

1997-2004 Vehicles: Proceed to the next step.

j. Twist the stock nipple carefully until it faces the

driver side of the vehicle.

k. Attach the supplied breather hose to the intake

pipe and the crank case ventilation nipple. Use

supplied 1” hose clamps to secure the hose.