Installation Manual

5
3. Installation of AEM
®
intake system.
a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until instructed
to do so.
b. Secure the reducing coupler to the throttle body
using the supplied #44 and #48 hose clamps.
c. Install the supplied 6mm rubber mount. Use the
supplied 6mm nut and 6mm washer. Attach the
bolt and secure from underneath the fender well.
d. Remove the bolt securing the radiator to the
core support. Slide the heat shield into position
and re-insert the stock bolt through the heat shield
hole and back through through the raditor support
from which it was removed from.
e. 2005-2006 Vehicles: Install the rubber grommet
into the intake pipe as shown.
1997-2004 Vehicles: Install the plug into the intake
pipe.