Manualshelf

Installation Manual

ManualsBrandsAEM ManualsAutomotiveAEM 21-8311DC Brute Force Intake System with Gun Metal Tube and Red Dry Filter for Jeep Wrangler TJ 1997 - 2006 4.0 L6
12345678
3
1. Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Disconnect negative battery terminal.
e. Do not discard stock components after removal of the factory system.
2. Removal of stock system
Read and understand these instructions BEFORE attempting to install this product.
Failure to follow installation instructions and not using the provided hardware may
damage the intake tube, throttle body and engine.
a. Factory air box configuration for Jeep Wrangler. b. Loosen the hose clamp located at the throttle
body.
c. 2005-2006 Vehicles: Push in and twist the “Inlet
Air Temperature” sensor out of the intake tube.
1997-2004 Vehicles: Proceed to the next step and
disregard this step.
d. Loosen the hose clamp connecting the intake
tube to the air filter lid.