Installation Manual

b. Place the splash shield in the location where

the air box tray was and align the holes.

c. Install the two stock bolts to loosely secure the

splash shield.

d. Install the heat shield over the splash shield

and line up the holes.

e. Install the 3 remaining stock bolts to secure the

heatshield and the splash shield.

3. Installation of AEM

intake system.

a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until instructed

to do so.

f. Install the rubber mount using the supplied

washer and M6 nut on the heat shield.

g. Install the 90° coupler on the throttle body and

loosely secure with the supplied #64 hose clamp.