Installation Manual

r. Lower the washer bottle assembly into place as

shown. Plug the washer hose and wire harness

connector to the pump. Plug in the level sensor

connector and tuck the wires away. Secure the

washer bottle into place with the two M6 bolts

removed in step 2h.

s. Refill the washer bottle with the washer fluid

drained in step 2h. Snap the blue cap onto the

neck of the washer bottle.

q. Stick the self-adhesive rubber pad onto the

small bump that protrudes from the washer bottle.

p. Apply a liquid soap solution to the level sensor

and insert it into the grommet. Make sure that the

level sensor is pressed all the way into the grom-

met. The lip of the sensor should sit inside the

groove of the grommet.