Installation Manual

f. From underneath the vehicle, install the air filter

with the #9460 hose clamp. Slide the air filter onto

the end of the inlet pipe until the pipe reaches

the stop inside the filter. Once proper fitment is

achieved, tighten the hose clamp.

g. If the vehicle is equipped with fog lights, un-

wrap the convoluted slit to expose the wires, then

remove the fog light wires.

h. Wrap the supplied convoluted slit over the

exposed fog light wires and secure with electrical

tape. Unclip the washer fluid hose from the clip

that attaches it to the inner fender. Push the hose

and the two wire connectors up top behind the

headlight.

i. Remove the blue washer fluid cap from the

stock washer bottle neck.

j. Using a flat head screwdriver, unclip the washer

pump from the washer bottle as shown.

k. Pry the washer pump out of the grommet and

set it aside. Also remove the grommet and set it

aside.