Installation Manual

9
n. Connect the two 5/32” hoses onto the two
nipples of the wastegate actuator exposed in step
2m. Then connect the two aluminum connectors
attached to the 5/16” hoses to the 5/32” hoses.
o. Install the aluminum intake pipe into the rubber
inlet hose. Align the intake pipe’s bracket to the
rubber mount, then secure the intake pipe to the
rubber inlet hose with hose clamp (9448).
p. Reconnect the bypass hose to the bypass valve
and secure it using the OE hose clamp.
q. Install the AEM
®
air lter onto the end of the
intake pipe and secure it with hose clamp (9452).
Reconnect the MAF sensor harness connector to
the MAF sensor.
r. Align the holes of the aluminum air box lid with
the threaded holes of the air box. Install 5 button
head screws and plastic washers to secure the lid
to the air box.
s. Using the 1/4” hose and the hose clamps
(4093-3), secure the hose to the bypass valve
nipple and the vacuum tube (exposed in step 2o).