Installation Manual

7
3. Installation of AEM
®
intake system.
a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until instructed
to do so.
b. Install the supplied rubber mount onto the air
box and secure it with a washer and lock nut.
NOTE: The rubber mount section should sit on
the outside of the air box.
c. The inlet duct should snap into place in the oval
opening of the air box. Also, install the edge trim
around the inlet hole on the rear side of the air
box.
d. Install the two OE rubber grommets onto the
bottom of the AEM
®
air box. The grommets were
removed from the stock air box in step 2u.
e. Place the AEM
®
air box in the engine bay,
aligning the two rubber grommets of the air box
with the two dowels protruding from the mounting
location.
f. Align the air box tab with the mount the OE air
box mounted to. Secure the air box to the mount-
ing tab with the bolt removed in step 2d. Do not
over torque the bolt, 15 ft-lbs.
g. Secure the inlet duct using the plastic rivets
removed in step 2g.