Installation Manual

3
1. Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Disconnect negative battery terminal.
e. Do not discard stock components after removal of the factory system.
2. Removal of stock system
Read and understand these instructions BEFORE attempting to install this product.
Failure to follow installation instructions and not using the provided hardware may
damage the intake tube, throttle body and engine.
a. Stock air box system installed. b. Disconnect the mass air ow (MAF) sensor
harness connector from the MAF sensor.
c. Using a small screwdriver remove the two tree
mount zip ties from the air box housing tabs.
d. Remove the bolt securing the OE air box to the
vehicle.