Installation Manual

n. Check closely for clearance around the air filter

and the AEM

MAF sensor adaptor, reposition as

needed.

4. Reassemble Vehicle

Engine Cover:

Install and secure the engine cover.

Fender liner and splashguard:

Install the fender liner, lower splash guard and any hardware that was

removed in steps 2f through 2h.

NOTE: Failure to install the fender liner will result in diminished performance and increase the

potential for engine damage due to water ingestion in rainy conditions.

Wheel:

Install the driver’s side wheel using the factory torque specification (see owner’s manual).

d. Position the inlet pipes for the best fitment. Be sure that the pipes or any other components do not contact

any part of the vehicle. Tighten the rubber mount, all bolts, and hose clamps.

e. Check for proper hood clearance. Re-adjust pipes if necessary and re-tighten them.

f. Inspect the engine bay for any loose tools and check that all fasteners that were moved or removed are

properly tightened.

m. Plug in the MAF senor. Place the engine

cover on the intake manifold and check for

clearance of the MAF sensor plug. Rotate the

MAF sensor assembly until the plug has

adequate clearance of the cover.