Installation Manual

l. Install the AEM

air filter onto the end of the

lower intake pipe. Make sure the air filter is fully

and squarely seated on the end of the pipe. Use

a #52 hose clamp to secure it in place.

j. Rotate the HID controller forward and reinstall

the screw in the other mounting hole on the

controller. Pull excess slack for the wires from

farther up the harness if needed.

k. Install the lower intake pipe in the end of the

coupler on the AEM

MAF adaptor. Line up the

bracket on the pipe with the rubber mount and

install the 6mm nylock nut and fender washer

(See diagram below). Do not completely tighten.

Proper installation of rubber mount assembly.