Installation Manual

7
f. Install the assembly from step 3c on the
upper intake pipe. Loosely install a #48 hose
clamp on the coupler. Make sure the MAF
sensor connector is pointing toward the oil cap.
g. Install the other 3” silicone coupler on the
end of the AEM
®
MAF adaptor. Loosely install
two #48 hose clamps.
i. If installing on a G35 Sedan, remove the
mounting screw for the HID headlight
controller.
NOTE: For G35 Coupe models ignore steps
3i.-3j. and proceed to step 3k.
h. Thread the rubber mount into the hole that
held the resonant chamber rear mounting bolt.
Hand tighten the rubber mount.