Installation Manual

6
3. Installation of AEM
®
intake system.
a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until
instructed to do so.
RUBBER MOUNT
SPACER
b. Using the 6mm bolts and washers included
in the kit, bolt the MAF sensor to the AEM
®
adaptor.
c. Slide one of the 3” straight silicone couplers
over the MAF sensor as shown. Lightly oiling
the inside of the coupler may help. Secure the
coupler in place using a #48 hose clamp.
e. Insert the upper intake pipe in the coupler as
shown. Reuse the factory hose clamp and
install the breather hose on the fitting on the
pipe. Do not tighten the #48 hose clamp.
d. Place the 3.25”-3.0” reducing silicone
coupler on the throttle body. Use a #52 hose
clamp around the throttle body. Make sure the
coupler is sitting squarely on the throttle body
and tighten the #52 hose clamp. Loosely
install a #48 hose clamp on the other end of
the coupler.