Installation Manual

4
g. From inside the wheel well, remove the two
plastic fasteners shown in the picture.
e. Pull directly upward on the air box to unsnap
it from the mounts. Remove the complete air
box system from the vehicle.
h. Peel back the splash guard and tuck it out of
the way. Remove the lower resonant chamber
circled in the picture.
Fastener #1
d. Remove the bolt holding the factory air box
in place. Unplug the Mass Air Flow (MAF)
sensor and unsnap the wiring loom form the
intake system.
i. Remove the air duct shown by removing the
three plastic fasteners holding it in place. (See
next page)
Fastener # 1
f. From underneath the car, remove the bolts
circled in the picture.
FRONT