Installation Manual

3
Read and understand these instructions BEFORE attempting to install this product.
Failure to follow installation instructions and not using the provided hardware may
damage the intake tube, throttle body and engine.
1. Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Disconnect all negative battery terminals.
e. Raise the front of the vehicle with a jack. Refer to your owner’s manual for proper jack and jack stand
placement to properly support vehicle. Support your vehicle using properly rated jack stands before wheel
removal or while working under the vehicle.
NEVER WORK UNDER A VEHICLE WITHOUT USING JACK STANDS.
i. Remove the driver side wheel.
f. Do not discard stock components after removal of the factory system.
2. Removal of stock system
a. Remove the four fasteners holding on the
engine cover. Remove the engine cover.
b. Remove the two plastic fasteners holding on
the air duct and remove the duct from the
engine bay.
c. Loosen the hose clamp holding the stock
intake tube on the throttle body. Loosen the
spring hose clamp on the breather hose and
pull the hose off of the fitting on the intake
tube.