Installation Manual

6
f. Install the inlet pipe into the coupler on the throttle
body. This should be done by sliding the bracket
side of the pipe through the hole in the inner fender.
Secure the pipe using a #40 hose clamp.
g. Align the inlet pipe mounting bracket with the
previously installed rubber mount. Secure the bracket
using the supplied M6 washer and nut.
h. Install the air lter on to the end of the lower inlet
pipe. Push the lter over the pipe until the stop in the
lter is reached. Use a #44 clamp to secure the lter
onto the inlet pipe.
i. Attach the stock breather hose to the nipple on the
inlet pipe using the factory spring clamp.
j. Plug the wiring harness into the IAT sensor mounted
in the intake pipe. Route the wires under the inlet pipe
to avoid scratching the pipe’s nish.