Installation Manual

3. Installation of AEM

intake system.

a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until instructed

to do so.

k. Stock air box system removed.

b. Install the straight coupler onto the throttle body

and secure using a #40 hose clamp.

c. Locate the front threaded hole where the stock air

lter housing was secured. Thread the supplied rub-

ber mount into the hole in the engine compartment as

shown.

d. Install the supplied rubber edge trim around the

hole in the inner fender.

e. Install the supplied grommet into the hole on the

inlet pipe. Gently press the IAT sensor into the grom-

met as shown.