Installation Manual

4
e. Loosen and remove the three bolts securing the air
lter housing to the chassis. Remove the housing and
the inlet hose by lifting straight up.
f. From the passenger side wheel well, remove the
nut and bolt secruing the inner splash shield to the
chassis.
g. From underneath the vehicle remove the two bolts
and two plastic connectors holding the splash shields
in place. Remove the lower shield and move the
fender well liner out of the way.
i. Remove the lower intake resonator.
h. Remove the two bolts, one plastic nut, and the plas-
tic retaining clip on the lower resonator and resonator
inlet pipe respectively.
j. Remove the inlet air temperature (IAT) sensor from
the stock inlet tube. This may be glued in place so use
a sharp knife to cut the glue along the gap and pull
the IAT out of the tube.