Installation Manual

9
5. CARB Sticker Placement
a. The C.A.R.B. exemption sticker, (attached), must be visible under the hood so that an emissions inspector can see
it when the vehicle is required to be tested for emissions. California requires testing every two years, other state
may vary.
6. Service and Maintenance
a. It is recommended that you service your AEM
®
Dryow™ lter every 20,000 miles for optimum performance. Use
AEM Dryow cleaning kit part # 21-110.
b. Use aluminum polish to clean your polished AEM
®
intake tube.
c. Use window cleaner to clean your powder coated AEM
®
intake tube. (NOTE: DO NOT USE aluminum polish on
powder coated AEM intake tubes).
AEM Air Intake System Warranty Policy
AEM
®
warrants that its intake systems will last for the life of your vehicle. AEM will not honor this warranty due to mechani-
cal damage (i.e. improper installation or tment), damage from misuse, accidents or ying debris. AEM will not warrant
its powder coating if the nish has been cleaned with a hydrocarbon-based solvent. The powder coating should only be
cleaned with a mild soap and water solution. Proof of purchase of both the vehicle and AEM intake system is required for
redemption of a warranty claim.
This warranty is limited to the repair or replacement of the AEM part. In no event shall this warranty exceed the original
purchase price of the AEM part nor shall AEM be responsible for special, incidental or consequential damages or cost
incurred due to the failure of this product. Warranty claims to AEM must be transportation prepaid and accompanied with
dated proof of purchase. This warranty applies only to the original purchaser of product and is nontransferable. Improper
use or installation, use for racing, accident, abuse, unauthorized repairs or alterations voids this warranty. AEM disclaims
any liability for consequential damages due to breach of any written or implied warranty on all products manufactured by
AEM. Warranty returns will only be accepted by AEM when accompanied by a valid Return Merchandise Authorization
(RMA) number. Credit for defective products will be issued pending inspection. Product must be received by AEM within
30 days of the date RMA is issued.
If you have a warranty issue, please call [phone] and our customer service department will assist you. A proof of
purchase is required for all AEM warranty claims.
For technical inquiries
e-mail us at
[e-mail]
or
call us at
800.992.3000
10-7034F
9/10/2014