Installation Manual
8
j. Install the supplied ½” breather hose between the
intake pipe and the valve cover. Secure with provided
1” hose clamps.
k. Reinstall the plastic battery under-tray, the bat-
tery, and the battery tie down bracket. Do not install
the plastic battery cover. Check for proper clearance
between the battery and the intake pipe. Use the sup-
plied zip-ties to make sure no wires are in contact with
the intake system.
Factory air box system AEM
®
intake system installed
4. Reassemble Vehicle
a. Fender Liner: Install the driver side fender liner and any hardware that was removed removed in step 2m.
b. Wheel: Install the driver’s side wheel using the factory torque specication (see owner’s manual).
c. Position the inlet pipes for the best tment. Be sure that the pipes or any other components do not contact any part
of the vehicle. Tighten the rubber mount, all bolts, and hose clamps.
d. Check for proper hood clearance. Re-adjust pipes if necessary and re-tighten them.
e. Inspect the engine bay for any loose tools and check that all fasteners that were moved or removed are properly
tightened.
f. Reconnect negative battery terminals and start engine. Let the vehicle idle for 3 minutes. Perform a nal inspec
tion before driving the vehicle.