Installation Manual

7
e. Secure the rubber mount using the supplied washer
and nylok nut.
f. Install the AEM
®
intake pipe by routing the air lter
end of the pipe through the opening in the engine bay
between the battery location and the fender. Use rags
to prevent scratches to the pipe.
g. Install the silicone coupler attached to the AEM
®
intake pipe over the throttle body.
h. Guide the bracket on the intake pipe over the stud
on the rubber mount. Once aligned, install the sup-
plied washer and nylock nut onto the stud.
d. Install the rubber mount where the factory wire loom
was removed.
i. Install the AEM
®
air lter onto the end of the intake
tube. Push the air lter over the intake pipe until the
stop in the air lter is reached. Then install one hose
clamp and secure the air lter onto the intake pipe.
Once tment is checked, tighten the hose clamp.