Installation Manual

q. Remove the two bolts securing the resonator box to

the frame. Remove the resonator box.

r. Release the wire loom from the hole in the fender.

3. Installation of AEM

intake system.

a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until instructed

to do so.

b. Install the provided 5/16” hose where the factory

coolant line was removed. Use the supplied 3/4” hose

clamps to secure the hose.

NOTE: Replace any coolant recovered during hose

removal by replenishing the recovery tank.

c. Check to see that the inside of the AEM

inlet pipe

and air lter are clean and free from any foreign ob-

jects and/or obstructions. Install the 3”-3.25” silicone

reducer over the throttle body end of the intake pipe

using the 3” hose clamps.

o. Remove the bolt securing the inlet tube to the

frame. This can be reached through the wheel well.

p. Using either a large screwdriver or a pry bar, pry the

inlet air tube from the resonator box. Remove the inlet

air tube.