Installation Manual

e. Loosen the hose clamp on the throttle body and un-

hook the wiring harness. Remove the stock breather

hose from the inlet tube.

f. Remove the plastic clips holding the wiring harness

to the throttle body side of the air lter housing.

g. Pull the inlet tube off the throttle body. Remove the

four screws holding the top of the air lter housing to

the lower air lter housing.

h. Remove wire clamp from the lower air box bracket.

i. Remove the two bolts securing the lower air lter

housing and remove housing. Pull up and remove the

rubber sleeve connecting the air lter housing to the

resonator below.

j. Remove the breather hose from the rear valve cover.