Installation Manual

3
1. Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Disconnect negative battery terminal.
e. Do not discard stock components after removal of the factory system.
2. Removal of stock system
Read and understand these instructions BEFORE attempting to install this product. Failure to
follow installation instructions and not using the provided hardware may damage the intake
tube, throttle body and engine.
a. Factory air box system installed. b. Remove plastic shrouding covering the battery.
Remove the plastic air scoop in front of the battery
by pulling out the two retaining clips and lifting scoop
straight out.
c. Remove the battery tie down and the two J-bolts
securing it. Carefully lift the battery out of the engine
compartment and set aside in a safe place.
d. Unclip the plastic battery shroud from the positive
terminal wire and remove the shroud.
The AEM
®
intake system is a performance product that can be used safely during mild weather
conditions. During harsh and inclement weather conditions, you must return your vehicle to
stock OEM air box and intake tract conguration. Failure to follow these instructions will void
your warranty.