Owners manual
5
a. Assemble your new AEM cold-side charge pipe as
shown according to the diagram on page 2 of this docu-
ment. Exclude the upper hose clamps for now.
b. Assemble your new AEM hot-side charge pipe as
shown according to the diagram on page 2 of this docu-
ment including the factory turbo coupler and vent hose.
c. Install the cold-side charge pipe onto the intercooler
rst with the throle body coupler slid all the way back
onto the tube as shown above.
3. Installation of AEM
®
intake system.
a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until
instructed to do so.
d. Slide the coupler over the throle body and install the
hose clamps. Ensure that both couplers have adequate
engagement of all mang surfaces.
k. Loosen the hose clamp securing the hot-side charge
tube to the intercooler using a 7mm socket at the end of
a universal joint on extensions as shown above.
l. Pull the factory hot-side charge tube out and remove
the recirculaon valve. This valve will be reinstalled on
your new AEM charge pipe.