Equipped with AEM ® Dryflow™ Filter No Oil Required! INSTALLATION INSTRUCTIONS PART NUMBER 26-3001C (Gun Metal Grey Finish) 2015-17 Ford Mustang 1 2.
ITEM NO. PART NUMBER DESCRIPTION QTY. 1 2-1523C TUBE; 2.5"OD X 29"L, FORD MUSTANG 2.3T HOT CHARGE 1 2 2-1530C* TUBE; 2.75"OD X 20"L, FORD MUSTANG 2.
Read and understand these instructions BEFORE attempting to install this product. Failure to follow installation instructions and not using the provided hardware may damage the intake tube, throttle body and engine. Tools Needed: 1. Preparing Vehicle a. Make sure vehicle is parked on level surface. b. Set the parking brake. c. If engine has run in the past two hours, let it cool down. d. Disconnect negative battery terminal. e. Do not discard stock components after removal of the factory system. f.
e. Use a 7mm socket to loosen the hose clamp securing the coupler to the turbo compressor inlet and remove the coupler from the turbo. f. Remove the factory intake assembly by lifting out as shown. g. With the factory intake system removed, begin removing the factory charge plumbing by loosening the clamp securing the cold-side charge hose to the throttle body using a 7mm socket. h. Loosen the clamp holding the other end of the hose to the intercooler.
k. Loosen the hose clamp securing the hot-side charge tube to the intercooler using a 7mm socket at the end of a universal joint on extensions as shown above. l. Pull the factory hot-side charge tube out and remove the recirculation valve. This valve will be reinstalled on your new AEM charge pipe. 3. Installation of AEM® intake system. a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until instructed to do so. a.
e. Install the hot-side charge pipe assembly onto the turbo outlet and intercooler inlet simultaneously. Ensure that both couplers have adequate engagement at the sealing surfaces. The hose clamps should fit entirely onto the coupler and behind the seal-bump features of the pipe. Reinstall the intake system and reconnect the vent hose from the recirculation valve to intake tube being sure to fully engage the spring clamps.
AEM Air Intake System Warranty Policy AEM® warrants that its intake systems will last for the life of your vehicle. AEM ® will not honor this warranty due to mechanical damage (i.e. improper installation or fitment), damage from misuse, accidents or flying debris. AEM ® will not warrant its powder coating if the finish has been cleaned with a hydrocarbon-based solvent. The powder coating should only be cleaned with a mild soap and water solution.
