Troubleshooting guide

DX2000-LCD - DigiSender® Plug’n’Go™ LCD
Please read this instruction manual carefully prior to installationPage 06
Step 3: Install the Receiver
Connect the Receiver into a Mains Extension
Lead. The positioning of the Receiver can affect
the picture quality so being able to move it is an
advantage.
2.
The DX2000-LCD Receiver will pick up the signals being sent by your DX2000-LCD Transmitter and out-
put them to a connected TV.
Press and hold the power button for 5 seconds to
turn the Receiver on. Pressing the button again
cycles through the 4 available channels. Make sure
it is set to channel 1.
3.
Locate a vacant SCART socket on the back of your
receiving TV and insert the DigiSender® SCART
cable.
1.
Position the IR Sensor on the top, side or bot-
tom of your receiving TV with the lens facing
out into the room.
4.