Specifications

Page 8
Online Support at www.digisender.net
DG440 DigiSender™ X7
STEP 3
Install the IR Systeme Technik™ remote extender
Once set up correctly, the remote
extender will enable you to utilise your
remote control in the remote location in
your home.
Because everyone’s set up is different
there are many ways you can install the
remote extender system.
Ex. 1
Ex. 2
Use accessories 1 and 2 to mount the IR Emitter
vertically with the IR emitting LED facing the
remote sensor of your source equipment.
Mount the IR Emitter horizontally using the
supplied sticky pad. Ensure the IR emitting LED is
facing the remote sensor of the source equipment.
LIVING ROOM
LIVING ROOM
Accessory #1
Extension Pieces
Accessory #2
IR Emitter
Page 17
Please read this instruction manual carefully prior to installation
DG440 DigiSender™ X7
TROUBLESHOOTING
Remote Control Extender
If you have any difficulty operating your source equipment remote control in
your second room please follow the advice below below:
1) Ensure the IR Systeme Technik™ IR Emitter is connected to the DigiSender™
transmitter.
2) Ensure you are using the correct remote control in the second room. For
instance, if you are trying to control your satellite channel you will need to use
the satellite remote control.
3) Ensure the IR Systeme Technik™ IR Emitter is facing the remote sensor on your
source equipment.
4) Move the IR Emitter further away from the source equipment using the
supplied extension accessory.
5) Move the transmitter AND receiver further away from other electrical devices.
6) Choose a new remote relay channel taking care that the same channel is
selected on both transmitter and receiver.
7) Operate the remote control closer
to the DigiSender™ receiver.
8) Replace the batteries in the
source remote control.